INSTRUCTIONS FOR CHANGING TONEARM CARTRIDGE HOLDER

Remove the lifter assembly as follows: Remove the two screws located on top of the assembly; this will expose all of the parts when the cover is lifted off. Remove the two screws at the bottom of the assembly which hold the unit to the chassis. After these are removed, the whole assembly will lift off the chassis (unplug). Make sure you do not lose the two small washers that the unit sits on and through which the two small screws go. Stand the unit on its back edge. Swing the tone arm out so that you have access to the two screws holding the cartridge holder in place. Remove these two screws. Unsolder the two wires from the old holder. Reassemble in reverse order.