AC-200 INSTRUCTIONS FOR REMOVING AMPLIFIER FROM CASE

Slide a screwdriver under the chrome handle cover and snap it off, exposing the two screws which hold the handle in place. Remove these screws. On the opposite side of the unit, locate the two rubber feet. Remove the screws that hold these two feet in place.

Before removing the amplifier from the case take off the platter and set it off to the side. Put a piece of masking tape over the brass well that the platter sits down in -- this will keep the ball bearing from falling out. Also, make sure the tone arm is locked in it's clip. Remove the power cord from it’s cage. The entire unit will now slide out of the carrying case.