TEMPORARY CONVERSION OF MICRO-75 WHICH WILL ALLOW YOU TO USE

50 HZ CURRENT, EVEN THOUGH YOUR UNIT IS CALIBRATED FOR 60 CYCLE.

Lift the turntable off of the spindle. With a small allen wrench remove the two set screws which hold the motor drive wheel to the motor shaft. (You will notice that as it is presently installed, the flat side of the drive wheel is nearest the motor). Remove the drive wheel and turn it around so that the flat surface is away from the motor and re-install it, tightening the set screws. Reinstall the turntable.

You will now be able to get 45 rpm at about 47 1/2 on the indicator setting and this will allow you to use it on a temporary basis.

If you want the unit permanently calibrated for 50 cycle so that all readings are exact, it must be returned to the factory for this service.

If you need further assistance or have any questions, please do not hesitate to contact us. We sincerely appreciate your continued support of the Hilton product line.