INSTRUCTIONS FOR CHANGING TONEARM ON MICRO 75

            There are five bolts which hold the entire assembly together. Two are on the right side, two are on the left side and one is on the top, directly under the turntable, near the center from right to left and located 3/4" back from the front edge.

            On the left side, one bolt is located 1/2" from the front and the other is located 3/8" from the back. On the right side, one bolt is located 1/2" from the front and the other is located 3/8" from the back. Remove all 5 of these bolts and the top will separate from the bottom.

Disconnect the two plug-in connectors and the two halves of the unit will separate. Set the speed control at 30 RPM.

SEE SKETCH BELOW. Remove these three bolts:

            After removing these three bolts, the power supply will drop down exposing the nut that holds the tone arm in place. Unsolder the two wires going to the tone arm, remove the nut and take out the old tone arm. Reassemble the unit in reverse order of above.