TO ADJUST THE MOTOR OFF MICROSWITCH IN MIRCO 75B OR 75C

Lift off the turntable platter and set it off to the side.

To remove the chassis from the case: stick a screwdriver under the chrome handle cover and snap it off. Remove the 2 screws holding the handle, and the 2 rubber feet on the opposite side. The chassis will now slide out of the case.

Turn the chassis up side down, on a pillow or other soft foam to protect the tone-arm.

Locate the microswitch mounted on a green fiberglass board on the tone-arm side of the motor. See drawing below to help you locate the microswitch. Make certain the turntable speed control knob is in the OFF position before continuing. Loosen the hex nut slightly and rotate the microswitch until there is about 1/16 inch of clearance between the leaf and the body of the switch. Retighten the nut.

Because the Microswitchs are not all exactly the same, check that adjustment has been made properly before securing the Micro-75B back in its case.

Reinstall the chassis in the case and the job if finished.